Influence of basic density and chemical composition of wood for the pulp industry: a case study
DOI:
https://doi.org/10.5902/1980509885566Keywords:
Wood quality, Eucalyptus, Pinus, CelluloseAbstract
The Eucalyptus and Pinus genera represent the main wood species which form the planted forests used by the pulp and paper sector in Brazil, and so many studies are conducted correlating the wood technological characteristics, the pulping process variables, and the pulp quality. The objective of this study was to perform a bibliographic review on studies that relate the basic density and chemical composition of wood with the pulping process variables and the pulp characteristics. The exploratory study principle was implemented through a literature review. The main studies found in this review showed that the best Eucalyptus clones used in the pulp industry had a basic density between 400 and 550 kg.m-³, unbleached pulp yield between 45 and 55%, kappa number 17-18, and brown pulp viscosity greater than 1200 g.cm-³. The best Pinus clones presented basic density varying between 370 and 440 kg.m-³, lower than the variation observed for Eucalyptus; a similar pulp yield to studies with Eucalyptus, varying between 45 and 51%; and kappa number 30-32, higher than that used in cooking with Eucalyptus wood. The results obtained in this work allowed to conclude that basic density was the most used wood characteristic in the pulp industries to guide the process yield, while the extractive content and the ratio of syringyl (S) and guaiacyl (G) units in lignin (S/G ratio) were little presented in research.
Downloads
References
ALMEIDA, J. M.; SILVA, D. J. Effect of extractives amount and liquor accessibility on Eucalyptus kraft pulping. In: 34º Annual Pulp and Paper Meetig. 22- 25 october. 2001. São Paulo. Proceedings... São Paulo: ABTCP, 2001.
ALVEZ, I. C. N. Potential of Eucalyptus benthamii Maiden et Cambage wood for kraft pulp production. 2010. 13p. Dissertation (Magister Scientiae in Forest Science) – Universidade Federal de Viçosa, Viçosa, 2010.
BARBOSA, L. C. A.; MALTHA, C. R. A.; SILVA, V. L.; COLODETTE, J. L. Determination of the siringyl/guaiacyl ratio in Eucalyptus wood by pyrolysis-gas chroma-tography/mass spectrometry (PY-GC/MS). Química Nova, São Paulo, v. 31, n. 8, p. 2035- 2041. 2008.
CARDOSO, G. V. Kraft pulping optimization for pulp production from Eucalyptus globulus woods with diferente lignin contents. 2002. 112f. Dissertation (Magister Scientiae in Forestry Engineering) - Universidade Federal de Santa Maria, Santa Maria, 2002.
DOS SANTOS, R.; DE MELLO JÚNIOR, J. A.; CARASCHI, J. C.; VENTORIM, G.; PEREIRA, F. A. Kraft and Kraft/aq pulping from prehidrolyzed wood of hybrid Eucalyptus urophylla x grandis. Ciência Florestal, v. 26, n. 4, p. 1281–1290, 2016.
DUARTE, F. A. S. Evaluation of the wood of Betula pendula, Eucalyptus globulus and of hybrid of Eucalyptus grandis x Eucalyptus urophylla as a raw-material for kraft pulp production. 2007. Dissertation (Magister Scientiae in Forest Resources) - Escola Superior de Agricultura Luiz de Queiroz, Universidade de São Paulo, Piracicaba, 2007.
GOUVÊA, A. F. G.; TRUGILHO, P. F.; COLODETTE, J. L.; LIMA, J. T.; DA SILVA, J. R. M.; GOMIDE, J. L. Wood evalution and Kraft pulping in eucalypts clones. R. Árvore, Viçosa-MG, v.33, n.6, p.1175-1185, 2009.
IBÁ – Indústria Brasileira de Árvores. 2023 Relatório anual. São Paulo: 2023. 91 p.
KOLLMANN, F.F.P. Tecnologia de la madera y sus aplicaciones. Madrid. Tomo I. Instituto Forestal de Investigaciones y Experiencias y Servicio de la Madera. 647p. 1959.
MEDEIROS NETO, H. F. Wood quality of Eucalyptus for kraft pulp production. 2012. 119p. Thesis (Doctorate in Forestry Sciences) – Universidade Federal de Viçosa, Viçosa, 2012.
MOKFIENSKi, A.; COLODETTE, J. L.; GOMIDE, J. L.; CARVALHO, A. M. M. L. Relative importance of wood density and carbohydrate content on pulping yield and product quality. Ciência Florestal, Santa Maria, v. 18, n. 3, p. 407-419, july-sept., 2008.
MORAIS, P. H. D. Effect of age of the wood of Eucalyptus in its chemical and pulpability, and bleachability and properties of the pulp. 2008. 65p. Dissertation (Magister Scientiae in Agrochemistry) – Universidade Federal de Viçosa, Viçosa, 2008.
PEREIRA, A. K. S.; LONGUE JÚNIOR, D.; MAFRA NETO, C. da S.; COLODETTE, J. L.; GOMES, F. J. B. Determination of the chemical composition and the wood pulping potential of Pterogyne nitens Tul. da composição química e potencial de polpação da madeira. Ciência Florestal, v. 29, n. 4, p. 1490–1500, 2019.
PEREZ, J. F. R. Pulp and wood quality from Eucalyptus globulus ssp provenances. 2002. 128 128 93f. Dissertation (Magister Scientiae in Forest Resources) -Escola Superior de Agricultura Luiz de Queiroz-Universidade de São Paulo, Piracicaba, 2002.
QUEIROZ, S. C. S.; GOMIDE, J. L.; COLODETTE, J. L.; DE OLIVEIRA, R. C. Effect of wood basic density on kraft pulp quality of hybrid Eucalyptus grandis W. Hill ex Maiden X Eucalyptus urophylla S. T. Blake clones. Revista Árvore, Viçosa, MG, v.28, n. 6, p. 901-909, nov./dec. 2004.
SANTOS, D. R. S. Technological assessment of Eucalyptus wood elite clones growing in Goiás State: wood quality for kraft pulp production. 2018. 165p. Dissertation (Magister Scientiae in Forest Resources) - Universidade de São Paulo Escola Superior de Agricultura “Luiz de Queiroz”, Piracicaba, 2018.
SEGURA, E. S. S. Evaluation of the woods of Corymbia citriodora, Corymbia torelliana and their hybrids for bleached kraft pulp production. 2015. 198p. Thesis (Doctorate in Forest Resources) – Universidade de São Paulo Escola Superior de Agricultura “Luiz de Queiroz”, Piracicaba, 2015.
SEGURA, E. S. S. Evaluation of the woods of Eucalyptus grandis x Eucalyptus urophylla and Acacia mearnsii for the kraft pulp production on conventional and Lo-Solids processes. 2012. 99p. Dissertation (Magister Scientiae in Forest Resources) – Universidade de São Paulo Escola Superior de Agricultura “Luiz de Queiroz”, Piracicaba, 2012.
TRUGILHO, P. F.; BIANCHI, M. L.; GOMIDE, J. L.; SCHUCHARDT, U. Classification of Eucalyptus sp clones for kraft pulp production. Revista Árvore, v. 28, n. 6, p. 895–899, dec. 2004.
VIVIAN, M. A.; SEGURA, T. E. S.; JÚNIOR, E. A. B.; SARTO, C.; SCHMIDT, F.; JÚNIOR, F. G. S.; GABOV, K.; FARDIM, P. Wood quality of taeda e Pinus sylvestris for kraft pulp production. Scientia Forestalis., Piracicaba, v. 43, n. 105, p. 183-191, may. 2015.
WEHR, T. F. A. Variations in the wood characteristics of E. grandis Hill ex maiden and its influences on the chip quality in kraft cookings. Piracicaba, 1991. 84p. Dissertation (Magister Scientiae in Forest Science) – Escola Superior de Agricultura “Luiz de Queiroz”, Universidade de São Paulo.
WENDEL, P. D. Study of xylans addition on kraft pulping and its impacts on the process development and the final product quality. 2014. 34p. Dissertation (Magister Scientiae in Pulp and Paper Technology) – Universidade Federal de Viçosa, Viçosa, 2014.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2024 Ciência Florestal
![Creative Commons License](http://i.creativecommons.org/l/by/4.0/88x31.png)
This work is licensed under a Creative Commons Attribution 4.0 International License.
A revista CIÊNCIA FLORESTAL reserva-se o direito de realizar, nos originais, alterações de ordens normativas, ortográficas e gramaticais, com vistas a manter o padrão escolar da língua, mas respeitando o estilo dos autores. As provas finais podem ou não ser enviadas aos autores.